环氧地坪的验收标准：
Acceptance standard of epoxy floor:
1、环境温度为25℃时，施工后2-3天应达到实干，即硬度达到完成固化的80%左右；
1. When the ambient temperature is 25 ℃, it should be dry 2-3 days after construction, that is, the hardness should reach about 80% of the completed curing;
2、表面不能出现发粘现象；
2. The surface should not be sticky;
3、气泡：平涂型、砂浆型无气泡，自流平允许1个小气泡/10平方米；
3. Bubble: flat coating type and mortar type without bubble, self leveling allows 1 small bubble / 10 square meters;
4、流平性好，无镘刀痕，大面积接口处基本平整;
4. Good leveling performance, no trowel mark, large area interface is basically flat;
5、无浮色发花，颜色均匀一致，大面积接口处允许有极不明显的色差；
5. There is no floating color, uniform color, and no obvious color difference is allowed at large area interface;
6、无粗杂质，但允许有空气中的浮尘掉落在造成的极小缺陷；
6. There are no coarse impurities, but the tiny defects caused by the floating dust in the air are allowed to fall;
7、地坪表面应平整平滑，光泽度应达到设计要求（高光泽≥90、有光≥70、半光50～70），平涂型为有光、水性为半光～无光；
7. The surface of the floor should be flat and smooth, and the glossiness should meet the design requirements (high gloss ≥ 90, gloss ≥ 70, semi gloss 50-70), and the flat coating type should be glossy and water-based semi gloss ~ matte;
8、桔皮、砂浆防滑面效果应很明显。无挥发性有机物排放，被广泛用于现代工业地坪的涂饰中。
8. The effect of orange peel and mortar anti sliding surface should be obvious. No volatile organic compounds emission, is widely used in modern industrial floor finishing.